Beginners Guide: Tips On How To Use Trencher Machine

rimrock

If you want to maintain your trencher teeth for a longer time, then you need to consider the issue of using the machine. If the machine is not used properly or as recommended by the manufacturer, you will definitely have a problem with your teeth.

In this article, we are providing you with the best tips on how to use your trenching machine. It is also important to mention the cutting performance of the trencher teeth is greatly determined by the manufacturer. JYFMachinery is one of the best trencher teeth manufacturers in the market. Check out their products.

The use of trencher machine should be done in steps. Note that the digging differs depending on the surface hardness and the depth that you want to go. Here are three major steps of using a trencher:

STEP 1

Prepare  the Machine

Start with preparing the trencher for the work. The first step in preparing the machine is to Turn the fuel switch on and give it a little bit of choke. Then turn on the key switch and have the throttle lowered a bit. You should now have the transmission put in neutral and then have the hydraulic pump turned off.

Now you can start with the trenching, lock the wheels in place and disengage the wheels for the unit to move. With the unit running, press the gas pedal and activate the hydraulic pump while the transmission pop forward.

 

STEP 2

Prepare for Digging

The digging process can be difficult if you don’t get it right. Therefore, you need to keep the machine in a perfect state and position to dig. Note that trenching is done in a straight line. This is one thing you need to get right for proper use of the trencher teeth and also for better output. When you get the trench in a position where you are digging, engage wheels so they work together.

Then you need to put the throttle up and throw the lever to start the chain spinning. Lower the bar into the earth or to the depth that you want, and the trencher will start digging.

 

STEP 3

Trench in reverse

The digging works when the machine is on reverse mode. Once the trencher is ready for digging, put the machine into reverse to start moving backwards. All the safety cautions must be observed when trenching. Avoid standing in front of the machine to avoid dirt and getting hit by the dug rocks.